Differences

This shows you the differences between two versions of the page.

--- apcaccu [2020/11/20 12:35] – chris
+++ apcaccu [2020/11/20 12:56] (current) – chris
@@ Line 1: / Line 1: @@
-**Change APC UPS Accu**
+**Change APC UPS Battery**
+This is an example for an APC 1400 UPS. Other APC's might be the same.
+{{:apc-back-ups-1400va.jpg?400|}}
+  - Get out the yellow fuse.
+  - Unscrew 4 screws on the top backside of the ups.
+  - Turn the UPS and loosen the from at the bottom side with two screwdrivers.
+  - Put 1 screwdriver in the opening and pull a little bit.
+  - Loosen the side notches with the other screwdriver until the front is off.
+  - Unscrew the 2 screws at the front.
+  - Lay-down the UPS on its side and remove the upper case with 2 screwdrivers.
+  - As the case comes loose, you will see 2 batteries. Disconnect and remove them.
+  - Remember the the cable layout!!!
+  - Black on minus **-000+** plus and minus with black short cable **-000+** red cable plus.
+  - With the batteries replaced, assemble the case.
+  - Put the upper case back, turn the UPS so it stands normally
+  - Return the two screws at the front in it's place.
+  - Put back the front and screw on the back with its 4 screws.
+  - Insert the yellow fuse.
+You should now be ready to go again with a fresh pair of batteries.
 \\